suphybrid2:start
This is an old revision of the document!
FAQ - Hybrid-2
Model: | Production year | |
---|---|---|
Hybrid 2 | - | |
![]() |
||
Brochure | https://www.d-r.nl/assets/hybrid-2-manual-smd-1.04.pdf | - |
Question: Could you give us an explanation about the dip switch of C-BALANCE? |
---|
Answer: The R balance works as an N-1 and can be set with connecting the input and listening at the output. |
Set the Send and Receive in the middle and the LC and HC to OFF. |
When called in adjust the potentiometer until the lowest input signal is heared. |
The C balance should be set to the situation that the Hybrid has the lowest influence on the bus that you listen to on the mixer. |
So if you offer a testing signal to a different channel and move the fader of the Hybrid the signal at the output shouldn't change. |
When this is okay you can fine adjust the R balance. |
The easiest way is to use a 1khz 0dB test tone for both settings and a scope but it is also possible by listening and watching the VU meters. |
suphybrid2/start.1612274005.txt.gz · Last modified: 2021/02/02 14:53 by support