D&R Wiki

There are two ways to find the IP address:

1) push the 4 encoders of module 1-4 at the same time when ‘None’ is selected.
This will show the IP address in the display and makes it possible to change the IP.
(push all 4 again, you can setup subnet mask etc. etc. → it is stored directly while turning an encoder)
(but a reboot is required to make the new IP setting active)

2) you also may run the Lyra Device Pool software that is added to the Lyra Software Bundle, which will show the Lyra and it's IP address if in the same network.

Lyra Software Bundle

Support Request