faderstartairlab:start
The easiest way to change the fader start settings in an Airlab is the Airlab Control Center.
Connect your Airlab to your PC by RS-232 cable or RS-232 to USB cable.
Be carefull not to connect to the Meter connector cause the +15 volt and -15 volt will harm the computer port.
Another way is to go into the setup by using the buttons and display at the Master section.
Return to Fader start instructions
Support Request
Go back to the Airlab support page.
faderstartairlab/start.txt · Last modified: 2022/07/18 09:18 by support