Question: What are the differences in versions?
Answer: Link: please read the info at this link
Attention !
| Be carefull due to a hardware change it is NOT possible to combine older versions with units produced after 01-01-2022 !!! | ||
|---|---|---|
| V.10 Main V.10 Extender | 01-01-2022 | POWER SUPPLY CHANGED TO 12 VOLT INSTEAD OF THE EARLIER USED 36 VOLT MAIN V.10 and EXTENDER V.10 ARE NOT COMPATIBLE WITH OLDER VERSIONS !!! Connecting a older to a newer units will damage the older unit !!! |
| Version | Date | Airence PCB info and modifications |
|---|---|---|
| V.1 | 06-12-2013 | - |
| V.2 | 14-01-2014 | Airence 1C > Airence 1D: Added Mic-on 2 circuit at Extender |
| V.3 | 18-11-2014 | Airence 2D > Airence 2E: USB noise reduced at Main |
| Airence Main and Extender fronts with Powder Coating | ||
| V.4 | 20-01-2015 | Airence 6E > C20, C38, C39, C40 replaced by 0R (wire), to prevent distortion at Announcer and Studio output |
| V.5 | 29-04-2015 | Airence 9B > Added 8x 100K resistor, protection for peak voltages when connecting a powered Extender |
| Airence Main new fronts without Master faders | ||
| V.6 | 28-05-2015 | Airence 9B > C64, C65, C66, C67 replaced by 0R (wire), for better ground connection |
| Airence Main and Extender remove powder coating at 15pin Sub D connector, for better ground connection | ||
| V.7 | xx-06-2016 | Airence Main 4, 5 and 6 pcb > SMD with different ledbar drivers |
| Airence Main Added Digital option | ||
| Airence 3 (Telco) > SMD with added Ring signal to Start jack | ||
| Airence Main Added 100N capacitor to remove Fader start noise in Audio | ||
| Airence V7 (Telco, Voip, Master 4, 5 and 6 pcb) not compatible with older versions due to Communication buss and Digital option. You'll have to replace the complete set except Airence 6 and 7! |
||
| V.8 | xx-11-2017 | Airence 3 (Telco) > R15, R17 replaced by leaded 600mW Resistors R17-R18 modification |
| V.9 | xx-05-2018 | Airence 3 (Telco) > R15, R17 replaced by SMD High power |
| xx-05-2018 | Airence 10E > Mac compatible | |
| V.10 Main V.10 Extender | 01-01-2022 | POWER SUPPLY CHANGED TO 12 VOLT INSTEAD OF THE EARLIER USED 36 VOLT MAIN V.10 and EXTENDER V.10 ARE NOT COMPATIBLE WITH OLDER VERSIONS !!! Connecting a older to a newer units will damage the older unit !!! |
