The easiest way to change the fader start settings in an Airlab is the Airlab Control Center.\\
Connect your Airlab to your PC by RS-232 cable or RS-232 to USB cable.\\
\\
Be carefull not to connect to the **__Meter__** connector cause the **__+15 volt and -15 volt__** will harm the computer port.\\
\\
{{ :faderstartinstr:airlab_gpo_settings.png?direct |}}\\
\\
\\
Another way is to go into the setup by using the buttons and display at the Master section.\\
\\
{{ :faderstartinstr:airlab_gpo_settings_a.png?direct |}}\\
{{ :faderstartinstr:airlab_gpo_settings_b.png?direct |}}\\
{{ :faderstartinstr:airlab_gpo_settings_c.png?direct |}}\\
\\
[[faderstartinstr:start|Return to Fader start instructions]]\\
\\
[[https://www.dnrbroadcast.com/support-related|Support Request]]\\
\\
Go back to the [[SupAirlab:start|Airlab]] support page.\\
\\