Differences

This shows you the differences between two versions of the page.

--- suphybrid2:start [2019/06/21 16:03] – support
+++ suphybrid2:start [2021/03/29 10:04] (current) – support
@@ Line 1: / Line 1: @@
 ====== FAQ - Hybrid-2 ======
+^  Model:  ^^  Production year  ^
+|  Hybrid 2  ||  -  |
+|  {{:tel-hybrid-2-2015_2x.png?200|}}  |||
+|  [[http://www.mambanet.org/assets/hybrid1-2-brochure.pdf|Brochure]]  |  [[http://www.mambanet.org/assets/hybrid-2-manual-smd-1.04.pdf|Manual]]  |  -  |
+\\
+^**__Question:__** Could you give us an explanation about the dip switch of C-BALANCE?^
+|**__Answer:__** The R balance works as an N-1 and can be set with connecting the input and listening at the output.|
+|Set the Send and Receive in the middle and the LC and HC to OFF.|
+|When called in adjust the potentiometer until the lowest input signal is heared.|
+|  |
+|The C balance should be set to the situation that the Hybrid has the lowest influence on the bus that you listen to on the mixer.|
+|So if you offer a testing signal to a different channel and move the fader of the Hybrid the signal at the output shouldn't change.|
+|When this is okay you can fine adjust the R balance.|
+|  |
+|The easiest way is to use a 1khz 0dB test tone for both settings and a scope but it is also possible by listening and watching the VU meters.|
 \\
 -----
 \\
-  * [[https://www.d-r.nl/wiki/dokudata/faq/hybrid2/HYBRID-2 RING VOLTAGE MEMO.pdf|HYBRID-2 RING VOLTAGE MEMO]]
+  * [[http://www.mambanet.org/wiki/dokudata/faq/hybrid2/HYBRID-2 RING VOLTAGE MEMO.pdf|HYBRID-2 RING VOLTAGE MEMO]]
-\\
------
 \\
+[[start:|{{:iconhome.png?100|Home}}]]