Differences

This shows you the differences between two versions of the page.

--- nwfwupdate:start [2019/07/22 09:24] – support
+++ nwfwupdate:start [2022/07/18 09:03] (current) – support
@@ Line 4: / Line 4: @@
 ==== Step 1 ====
-  * Be sure that the USB cable is connected.
+  * Be sure that the USB cable is connected.\\
-  * Be sure that the original USB cable is used or a cable with a maximum length of 1,8 meter (6ft).
+  * Be sure that the original USB cable is used or a cable with a maximum length of 1,8 meter (6ft).\\
-  * Don't use Extender cables or Hubs, connect it to a port directly on the mainboard.
+  * Don't use Extender cables or Hubs, connect it to a port directly on the mainboard.\\
-  * Did you download and select the right firmware?
+  * When connecting the unit did you receive an error that there aren't enough end points or resources? Then there is probably an xHCI or different usb problem. [[usbnotworking:start|Please follow the steps at this link]]
+  * Did you download and select the right firmware?\\
+\\
 ==== Step 2 ====
@@ Line 36: / Line 38: @@
 Also take a look at this document:
-[[https://www.d-r.nl/wiki/dokudata/software/Firmware Update v2.0.pdf|Firmware update "AtLibUsbDfu.dll not found"]]
+[[http://www.mambanet.org/wiki/dokudata/software/Firmware Update v2.0.pdf|Firmware update "AtLibUsbDfu.dll not found"]]
 ==== Step 6 ====
@@ Line 42: / Line 44: @@
 If the firmware update tool still doesn't work after these steps fill in the support contact form.
 \\
-[[https://www.d-r.nl/support-request.html|Support Request]]\\
+[[https://www.dnrbroadcast.com/support-related|Support Request]]\\
+\\
+Go back to the [[SupAirence:start|Airence]] support page.\\
 \\
 Go back to the [[SupAirlab:start|Airlab]] support page.\\
@@ Line 52: / Line 56: @@
 Go back to the [[SupGSMHybrid:start|GSM Hybrid]] support page.\\
 \\
+[[start:|{{:iconhome.png?100|Home}}]]