nwfwupdate:start
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| nwfwupdate:start [2018/12/06 10:52] – support | nwfwupdate:start [2022/07/18 09:03] (current) – support | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| **__Question: | **__Question: | ||
| - | **__Answer: | + | **__Answer: |
| ==== Step 1 ==== | ==== Step 1 ==== | ||
| - | * Be sure that the USB cable is connected. | + | * Be sure that the USB cable is connected.\\ |
| - | * Be sure that the original USB cable is used or a cable with a maximum length of 1,8 meter (6ft). | + | * Be sure that the original USB cable is used or a cable with a maximum length of 1,8 meter (6ft).\\ |
| - | * Don't use Extender cables or Hubs, connect it to a port directly on the mainboard. | + | * Don't use Extender cables or Hubs, connect it to a port directly on the mainboard.\\ |
| - | * Did you download and select | + | * When connecting |
| + | * Did you download and select the right firmware?\\ | ||
| + | \\ | ||
| ==== Step 2 ==== | ==== Step 2 ==== | ||
| Line 36: | Line 38: | ||
| Also take a look at this document: | Also take a look at this document: | ||
| - | * [[https://www.d-r.nl/ | + | [[http://www.mambanet.org/ |
| ==== Step 6 ==== | ==== Step 6 ==== | ||
| If the firmware update tool still doesn' | If the firmware update tool still doesn' | ||
| - | + | \\ | |
| - | [[https:// | + | [[https:// |
| + | \\ | ||
| + | Go back to the [[SupAirence: | ||
| + | \\ | ||
| + | Go back to the [[SupAirlab: | ||
| + | \\ | ||
| + | Go back to the [[SupAirlite: | ||
| + | \\ | ||
| + | Go back to the [[SupWebstation: | ||
| + | \\ | ||
| + | Go back to the [[SupGSMHybrid: | ||
| + | \\ | ||
| + | [[start: | ||
nwfwupdate/start.1544089945.txt.gz · Last modified: 2018/12/06 10:52 by support