Differences

This shows you the differences between two versions of the page.

--- suphybrid2:start [2020/03/02 11:10] – support
+++ suphybrid2:start [2020/05/29 10:07] – support
@@ Line 2: / Line 2: @@
 {{:tel-hybrid-2-2015_2x.png?200|}}
 \\
-**__Question:__** Could you give us an explanation about the dip switch of C-BALANCE?\\
+^**__Question:__** Could you give us an explanation about the dip switch of C-BALANCE?^
-**__Answer:__** The R balance works as an N-1 and can be set with connecting the input and listening at the output.\\
+|**__Answer:__** The R balance works as an N-1 and can be set with connecting the input and listening at the output.|
-Set the Send and Receive in the middle and the LC and HC to OFF.\\
+|Set the Send and Receive in the middle and the LC and HC to OFF.|
-When called in adjust the potentiometer until the lowest input signal is heared.\\
+|When called in adjust the potentiometer until the lowest input signal is heared.|
-\\
+|  |
-The C balance should be set to the situation that the Hybrid has the lowest influence on the bus that you listen to on the mixer.\\
+|The C balance should be set to the situation that the Hybrid has the lowest influence on the bus that you listen to on the mixer.|
-So if you offer a testing signal to a different channel and move the fader of the Hybrid the signal at the output shouldn't change.\\
+|So if you offer a testing signal to a different channel and move the fader of the Hybrid the signal at the output shouldn't change.|
-When this is okay you can fine adjust the R balance.\\
+|When this is okay you can fine adjust the R balance.|
-\\
+|  |
-The easiest way is to use a 1khz 0dB test tone for both settings and a scope but it is also possible by listening and watching the VU meters.\\
+|The easiest way is to use a 1khz 0dB test tone for both settings and a scope but it is also possible by listening and watching the VU meters.|
 \\
 -----