suphybrid2:start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
suphybrid2:start [2019/06/21 16:03] – support | suphybrid2:start [2020/03/02 11:10] – support | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== FAQ - Hybrid-2 ====== | ====== FAQ - Hybrid-2 ====== | ||
+ | {{: | ||
+ | \\ | ||
+ | **__Question: | ||
+ | **__Answer: | ||
+ | Set the Send and Receive in the middle and the LC and HC to OFF.\\ | ||
+ | When called in adjust the potentiometer until the lowest input signal is heared.\\ | ||
+ | \\ | ||
+ | The C balance should be set to the situation that the Hybrid has the lowest influence on the bus that you listen to on the mixer.\\ | ||
+ | So if you offer a testing signal to a different channel and move the fader of the Hybrid the signal at the output shouldn' | ||
+ | When this is okay you can fine adjust the R balance.\\ | ||
+ | \\ | ||
+ | The easiest way is to use a 1khz 0dB test tone for both settings and a scope but it is also possible by listening and watching the VU meters.\\ | ||
\\ | \\ | ||
----- | ----- |
suphybrid2/start.txt · Last modified: 2021/03/29 10:04 by support