Differences

This shows you the differences between two versions of the page.

--- suphybrid2:start [2019/06/21 16:03] – support
+++ suphybrid2:start [2019/07/26 11:30] – support
@@ Line 1: / Line 1: @@
 ====== FAQ - Hybrid-2 ======
+\\
+**__Question:__** Could you give us an explanation about the dip switch of C-BALANCE?\\
+**__Answer:__** The R balance works as an N-1 and can be set with connecting the input and listening at the output.\\
+Set the Send and Receive in the middle and the LC and HC to OFF.\\
+When called in adjust the potentiometer until the lowest input signal is heared.\\
+\\
+The C balance should be set to the situation that the Hybrid has the lowest influence on the bus that you listen to on the mixer.\\
+So if you offer a testing signal to a different channel and move the fader of the Hybrid the signal at the output shouldn't change.\\
+When this is okay you can fine adjust the R balance.\\
+\\
+The easiest way is to use a 1khz 0dB test tone for both settings and a scope but it is also possible by listening and watching the VU meters.\\
 \\
 -----