faderstartairlab:start
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| faderstartairlab:start [2019/06/11 10:06] – support | faderstartairlab:start [2019/06/11 10:08] – support | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| The easiest way to change the fader start settings in an Airlab is the Airlab Control Center.\\ | The easiest way to change the fader start settings in an Airlab is the Airlab Control Center.\\ | ||
| Connect your Airlab to your PC by RS-232 cable or RS-232 to USB cable.\\ | Connect your Airlab to your PC by RS-232 cable or RS-232 to USB cable.\\ | ||
| - | Be carefull not to connect to the __Meter__ connector cause the Computer will get +15 volt and -15 volt at his data line.\\ | + | \\ |
| + | Be carefull not to connect to the **__Meter__** connector cause the **__+15 volt and -15 volt__** will harm the computer port.\\ | ||
| + | \\ | ||
| {{ : | {{ : | ||
| \\ | \\ | ||
faderstartairlab/start.txt · Last modified: 2022/07/18 09:18 by support